PuffNStuff Posted July 22, 2008 Share Posted July 22, 2008 Well, i have never uploaded anything.... good anyways. So i decided to render an ongoing project. This was drafted used two programs. It started in Autodesk Inventor, then I imported it to Solidworks. Its pretty cool.... Link to comment Share on other sites More sharing options...
Guest krystal08 Posted July 22, 2008 Share Posted July 22, 2008 Its nice!but....i don't really see what it is.i think i know, but i don't know the word in frensh its "grapin" and i think i made a fault but i don't have any dictionnary. but its realistic and i like it. Link to comment Share on other sites More sharing options...
PuffNStuff Posted July 22, 2008 Author Share Posted July 22, 2008 It is a foot assembly for a prototype mech i want to build someday. Those are toes attached to a main boot that has a leg on a slide joint. It is all hydrolically controlled so there are a lot of cylinders. Sometime I will see if I can make the design more efficient. Link to comment Share on other sites More sharing options...
DZComposer Posted July 23, 2008 Share Posted July 23, 2008 Wrong Board. Link to comment Share on other sites More sharing options...
Mr. Krystal Posted July 23, 2008 Share Posted July 23, 2008 Nice! I had no trouble figuring out what it was. I like where it's going. Link to comment Share on other sites More sharing options...
Guest krystal08 Posted July 23, 2008 Share Posted July 23, 2008 Haaaaaa!i can't wait to see the final product of your mech! Link to comment Share on other sites More sharing options...
Recommended Posts